cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X

Why are my simple model files getting so large

MichaelMontagna
1-Newbie

Why are my simple model files getting so large

I’m at a loss with this problem. I've noticed
that the file size of some of my simple models seem to be very large at times. Here is
one example. A washer 1" ID washer with some radii. I created it with a revolve
and some extrudes. It has one draft feature but if I delete that feature and
resave, the file size hardly changes. The accuracy of the model is absolute at
.0001". I have tried changing that too but it doesn't seem to effect the
.PRT model size. The file size of this example is 27,700KB


Creo Parametric 2.0 M50


Any help would be greatly appreciated.


Mike Montagna


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

Jay wrote in response to below and my file size went from 27,700 KB to 350 KB. Thanks Jay!


Mike,


One thing I have noticed in other versions of ProE, yes I
still call it ProE, is the config option for save_model_display. If it is
set to shaded, the file size increases dramatically. Set to wireframe and
the file size is ten times smaller. Good Luck with the
troubleshooting.


Regards,


Jay



In Reply to Michael Montagna:



I’m at a loss with this problem. I've noticed
that the file size of some of my simple models seem to be very large at times. Here is
one example. A washer 1" ID washer with some radii. I created it with a revolve
and some extrudes. It has one draft feature but if I delete that feature and
resave, the file size hardly changes. The accuracy of the model is absolute at
.0001". I have tried changing that too but it doesn't seem to effect the
.PRT model size. The file size of this example is 27,700KB


Creo Parametric 2.0 M50


Any help would be greatly appreciated.


Mike Montagna


Top Tags