cabling

[ptc-4991971]

I am new for Creo2-Cabling, Please help? would like to create Hose pipe for cables in assembly. I am expecting step by step procedure.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[rkrishna]

Create a spool and route the hose as per your requirement and pack the necessary wire in it...

[ptc-6294531]

Click on the "Spools" icon in the cabling ribbon, this will give a pop-up menu, click here on "Sheath."

Then use the help fuction and look for "To Create a Spool" this will give you the nessasary info to create your tube.

As far as the cabling/routing goes, you can also look up "Routing Techniques" & "Cabling Overview" in the help function (although some of the help function is still only for Creo 1).