Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
I have attached images of a bottle I was asked to model. So far this has been beyond my knowledge/skills.
Does anyone have suggestions on how to tackle modeling this bottle? A particularly difficult zone is the dome on the top.
best regards, al
using wf 3.0
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Depending on the level of accuracy required, I would suggest a series of sweeps, blends or sweep/blends. Build half the bottle and mirror the base model and add the cap threads.
I might even consider an outside "scanning" service to bring the shape into Creo and then work with this "known geometry".
