dimension units trouble / confusion
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
dimension units trouble / confusion
Hello,
I have a part with units set to Inch lbm Seconds (Creo default).
I have a drawing with "drawing_units" set to inches in the dtl.
But shown and created dimensions both are in millimeters.
They are displayed with 2 decimal places, but if I go to the dimension's properties, the decimal places is set to my default "3"
Something is over-riding all of my settings. Anyone have an idea what it could be?
Thanks!
-Nate
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Solved! Go to Solution.
- Labels:
-
2D Drawing
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Ha - found it.
In my DTL there is a setting "dual_dimensioning" that was set to "secondary"
I changed it to "no" and my "mm's" changed to "in's"
Thanks for reading...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Ha - found it.
In my DTL there is a setting "dual_dimensioning" that was set to "secondary"
I changed it to "no" and my "mm's" changed to "in's"
Thanks for reading...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
And I marked myself correct - I wonder if they'll give me my 3 points?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Great monolog. l like thise situations, when it happen myself
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
I just needed the forum to intimidate me to think on my own...!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
And by the way you do get 3 points for answering your own question.