fid # help

[EricHuffman]

Gurus,

I've got an assembly drawing and I'm calling out an analysis feature
parameter of a component via a leader note. The note says &MASS:FID_74:5
and works fine. I understand that the 74 is the feature id but I cannot
figure out what the 5 is representing. This number is auto generated
after I place the note. Any ideas?

Thanks,

Eric



Wildfire 4.0 Datecode m090

Windchill 9.0 Datecode m030














This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[lwh]

It's the component number in the assy.