geometry check
Aug 28, 2012
08:32 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Aug 28, 2012
08:32 PM
geometry check
In 3D modeling, if it has geometry check. Would that mean the model has an error?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
1 REPLY 1
Aug 28, 2012
11:30 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Aug 28, 2012
11:30 PM
It depends on severity. I believe it is just letting you know there may be something noteworthy where you can simply reply with "ignore". The error is described in the text in the lower panel.
If you had a true error that requires attention, your regeneration manager at the bottom of the Creo window will go yellow or red.
