precision of Drawing parameter

[Ketan_Lalcheta]

Hello,

I would like to know what need to be done in order to have precision as 2 for newly added  parameter into drawing file.

Thanks and Regards

Ketan

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[dmcclinton]

Ketan

I am not sure you can actually control the precision of a parameter, but you can control the number of decimal places displayed in a note or table by adding [.2] in the note.

some note whatever &some_parameter[.2]

Dave

[TomU · Accepted solution]

You may also want to read these discussions:

Re: Parameter Decimal Place

Re: Decimal Places Change

Re: Decimal difference model vs drawing

[Ketan_Lalcheta]

Parameter Decimal Place thread provided required solution... Thank you every one for addressing my issue.

[mmadrid]

drawing option > dual_digits_diff > -2

good luck!