cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X

precision of Drawing parameter

Ketan_Lalcheta
19-Tanzanite

precision of Drawing parameter

Hello,

I would like to know what need to be done in order to have precision as 2 for newly added  parameter into drawing file.

Thanks and Regards

Ketan


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
ACCEPTED SOLUTION

Accepted Solutions
TomU
23-Emerald IV
(To:Ketan_Lalcheta)
4 REPLIES 4

Ketan

I am not sure you can actually control the precision of a parameter, but you can control the number of decimal places displayed in a note or table by adding [.2] in the note.

some note whatever &some_parameter[.2]

Dave

TomU
23-Emerald IV
(To:Ketan_Lalcheta)

Ketan_Lalcheta
19-Tanzanite
(To:TomU)

Parameter Decimal Place thread provided required solution... Thank you every one for addressing my issue.

drawing option > dual_digits_diff > -2

good luck!

Sin título.png

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags