Hi,
Need some help, I just installed Creo 1.0 Student edition I was using Wildfire 5.0. However now when I try and open assemblies created in Wildfire 5.0 the program either crashes or the assembly opens looking completely different from original assemblies. .PRT's seem to open OK, its just .ASM's that are causing problems. Any help is much appreciatted.
Thanks
Matt
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
