cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

rip

bmozley
5-Regular Member

rip

I have a simple rip and a tab bent up but I can't seem to get a flat
pattern to work. I must be missing something, Do I need to merge the rip
in some way ?

See pic.



Brad


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

I've had the flat pattern not work once or twice. It was due to very complex bending of the part. I did find though that an unbend all worked. On another odd note, after more manipulation the flat "magically" worked again. Try an unbend all.

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags