Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
I copied ansheet metal part and got the drawing copied as well. When I showed the bend notes for the new part, the notes had moved from above the line to below the line. See Attached. This is consistant throughout the drawing. Does anyone know how to change this back, or how it occurred? TIA
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
I'm not for sure how it occurred in your situation, but I always thought that it was ABOVE the line if it was a bend UP, and BELOW the line if it was a bend DOWN.
