i work with multiple impressions and progressions in drop hammer forge dies, there is a small amount of "stretch" in the bottom die because of heat transfer.
in order to compensate for it i change the impression locations slightly in the top die.
is there anyway to keep the pattern locations tied to a specific half of the mold cavity?
or is there a better way to create the top and bottom die design without drawing the mold design layout twice?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
