cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Import constraints from Creo parametric to Creo Illustrate

ptc-4890452
1-Newbie

Import constraints from Creo parametric to Creo Illustrate

Hi all.

I have an assembly in Creo parametric containing a pin-connection between two parts. The one part is able to rotate around the other, with the pin-connection as pivot point.

Is it somehow possible to maintain this connection when importing the assembly to Creo Illustrate, and use it when repositioning parts here?

Best regards

Esben Oxholm

3 REPLIES 3
VladimirN
23-Emerald IV
(To:ptc-4890452)

Esben Oxholm Bonde wrote:

... Is it somehow possible to maintain this connection when importing the assembly to Creo Illustrate, and use it when repositioning parts here?...

Best regards

Esben Oxholm

No, you will need to re-set the connection in Creo Illustrate.

Okay. Thanks for the answer...

Too bad it is not possible. Would save a lot of time.

VladimirN
23-Emerald IV
(To:ptc-4890452)

Esben Oxholm wrote:

... Would save a lot of time.

Agree.

Announcements