cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Creo Simulate keeps crashing when running AutoGEM and prompts an assertion failure

DEASEY
3-Visitor

Creo Simulate keeps crashing when running AutoGEM and prompts an assertion failure

I am using Creo Simulate Release 6.0 and Datecode6.0.6.0

When trying to run AutoGEM, fails and microsoft visual c++ prompts the following. "Assertion Failed! File s:/sim/common/src/data_mgr/fastener/MechFastener.cxx line 340. Expression: UndefDbid != dbidPreLoadSpring"

1 ACCEPTED SOLUTION

Accepted Solutions
VladimirN
23-Emerald IV
(To:DEASEY)

3 REPLIES 3
VladimirN
23-Emerald IV
(To:DEASEY)

 Hi,

 

Read this article - "Pro/Mechanica analysis fails with message "Assertion Failed! File s:/sim/common/src/data_mgr/fastener/MechFastener.cxx line 275. Expression: UndefDbid != dbidPreLoadSpring"": https://www.ptc.com/en/support/article/cs157250 

Thank you for responding. 

Thought the lines being different could have referred to a different issue but will look into that. Thank you. 

VladimirN
23-Emerald IV
(To:DEASEY)

You're welcome.

Announcements