Flow Analysis Post Processing

[AC_PH]

Reference topic: https://community.ptc.com/t5/Analysis/Flow-Analysis-Post-Processing/m-p/871276#M11296 

Hello @MB_10584523 !

Thanks for this post ... I have the same question or the same request. It would be great if PTC would enable calculation of average and mass averaged report for velocity (so, similar as for total pressure). This option should be available either through XYPlot either/and through interface output property.

 

@tmoser : good advice until implementation of my proposal into Creo. 😀

Have a good day

[Catalina]

Hi @AC_PH 

Thank you for your question. 

Your post appears well documented but has not yet received any response. I am replying to raise awareness. Hopefully, another community member will be able to help.

Also, feel free to add any additional information you think might be relevant. 

Best regards,

[cfdgeek]

Hi  AC_PH,

Thanks for your suggestions. We will discuss this internally and expand the output list. In the meantime, you can use expression editor to compute a user defined output e.g. mess averaged pressure at any boundaries etc. It is very straightforward. All other suggestions are welcome, you can email to support@simerics.com or directly to me ls@simerics.com thanks.