Trajectory Simulation
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Trajectory Simulation
Dear all
please help me in this case
I have three trajectories & I have a cylinder that
slide up & down while the trajectories rotate
when the 1st one rotate it make the cyl doesdown
for 2mm then when the second rotate it make goes
down for another 2mm &the the third hassame senario
Ihave to mention that every one of the trajectories
has its shape to let the cylmove up or down
the problem I tried to use cam follower but the sys
refuse to identify the trajectory as a cam
I used a slot connection it works fine for one
trajectory but when I tried to add the second
trajectory nothing goes right
I added a pic that i hope it may explain the
problem
please help me as soon as possible
thanks alot
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
- Labels:
-
General
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Verify that that movement is only in 2 directions.
As far as I know, 3 dimensional cams are still not supported by Pro/Mechanism. (Hopefully this has been fixed)
See if cam liftoff is enabled.
Hope this helps,
Don Anderson
Don Anderson
No time Like the Present!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator