Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
I keep getting the warning message "highlighted snap lines can not be regenerated" in drawing mode for some of our template models. However, no matter what I do, I cannot see any snap lines, highlighted or not. Is there some way I can get these snap lines to be visible so I can figure out why they can't be regenerated?
Thanks.
We're running WF3, M160
--
Lyle Beidler MGS Inc 178 Muddy Creek Church Rd Denver PA 17517 717-336-7528 Fax 717-336-0514 <">mailto:-> - <">http://www.mgsincorporated.com> This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
