Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
Good afternoon!
I'm currently in the midst of a project whereby measurements from a CREO CAD assembly will drive data in a MathCAD document.
It should be possible to mark variables as either read or write for the inbuilt MathCAD analysis tool within CREO.
I remember being told at one point that the variables need to be marked or labled using a string.
I think it was along the lines of 'creo2mc'
Does anyone have any information around this issue?
Regards,
Alex