Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
Thanks to Brian Lynn who pointed out that the coordinate system creation for a coordinate system is located under the point button in sketcher. I am now able to get a toroidal bend but I can only specify the angle of the bend. What I want is to be able to specify the bend radius and have the bend angle determined by the system.
> Dwayne Quatier > GE Healthcare > Ultrasound > Product Development Engineer > T 480-222-7003 > F 480-760-2489 > E - > www.gehealthcare.com > 365 S. 52nd St > Tempe, AZ, 85281, USA >