Creo Behavioral Modeling Tips & Techniques Session Recording (East Coast)

[#1]

Check out this video on Creo Behavioral Modeling from PTC Application Engineers!

Presenters:  Mark DeCraene (Generalist Application Engineer, Principal), Lino Tozzi (Technical Specialist, Fellow) and Ryan Butcher (Technical Specialist, Fellow)

To dive deeper into the subject, check out PTC University.

[Dayna_M]

Webcast Q&A

Question from Anand:  Is Behavioral_Modeler_SET license module similar to the BMX module?

Answer:  Yes, that is correct.

[Dayna_M]

Webcast Q&A

Question from Blake:  When using behavioral analysis, does the CAD model need to be built with connections, similar to Mechanism Dynamics?  Connections such as springs, dampers, force torque loads, etc.?

Answer:  Only if the assembly you are analyzing is a mechanism.

[Dayna_M]

Webcast Q&A

Question from David:   When doing a more complicated feasibility analysis that has more than a few design constraints or design variables fail, is there an easy way to see what constraint caused the failure?

Answer:  The feasibility will fail but the issue could be with one dimension or the combination of the change of multiple dimensions.  It's best to start small with 1 or 2 dimensions for feasibility and grow from there.

[ZJ_9299410]

How to get the source model
---------------------------------------

Translated the below text from Simplified chinese to english using google translate. By community Moderation team.

Simplified Chinese: 如何获取源模型
---------------------------------------