Check out this video on Tool Design/Mold Analysis from PTC Application Engineers
Presenters: Lee Goodwin (Technical Specialist, Principal) and Lino Tozzi (Technical Specialist, Fellow)
Original Date Presented: September 14, 2021
To dive deeper into the subject, check out PTC University.
- Chapters
- descriptions off, selected
- captions settings, opens captions settings dialog
- captions off, selected
This is a modal window.
Beginning of dialog window. Escape will cancel and close the window.
End of dialog window.
This is a modal window. This modal can be closed by pressing the Escape key or activating the close button.
Webcast Q&A
Question from Jon: I'm a member of ASME Y14.8 Castings, Forgings and Moldings. Would you have any recommendations pertaining to the standard: good or bad symbols? Useful concepts such as datum targets? Short comings to be addressed?
Answer: I am assuming this is for detailing purposes. At this moment we support up to ASME Y14.5.