cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Reassign shape problem

Highlighted
Participant

Reassign shape problem

Hi!

I have a BID-WID diagram in schematics, and I have to copy (with cut) a part of the wiring to another sheet. When I do this all artifacts lose their co shapes in the wiring. So I've tried to reassign the shapes, but it gives me various errors, and I so I cant make it happen.

Block diagram:

block_det.JPG

The part of the block diagram, it contains block and also group artifacts too.

The WID of it:

Wiring_det.JPG

I cut this (ctrl+x, or right click CUT, doesen't matter) to another sheet.

If I try to reassign the shape of the wiring connector J-03 to J-02 (picture shows J-02 on wiring because it was taken before the cut-paste) it gives me the following error message:

det_err1.JPG

If I try to do the same with the heater element the error message is the following:

det_err2.JPG

But If I try the same on the block diagram with the connector J-03 it works (it doesn't work with the block artifacts like this neither), just the name won't be the same as before, and that's not acceptable.

I had this problem before, then I had to add the connectors again (in case of a 37 pin D-SUB connector it's not so easy, reordering the members one by one, not the best thing to do).

Do you have any idea why this happens? Thanks!

Regards,

Laszlo

Tags (1)