3D connexion device is not working with Drafting, while is working with Modelling. Did someone solve the problem?

[glonga]

Hi everybody,

I’m using both Modelling and Drafting and I noticed that 3D connexion devices are not working with drafting.

Did someone have the same problem and find a solution?

Thanks

Giovanni

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[wdesmet]

Hi Giovanni

I have noticed the same problem as well and notified PTC support about the issue. unfortunatly,at this time there is no solution available, but it was said this will be fixed in Modeling/Drafting version 19.0 M030, comming out in September

Best regards

Ward