Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts! X
Hi,
How to add arc length symbol in the drawing as shown in red loop in the attached snap. Please explain step by step. (CREO ELEMENTS)
Regards,
Nidhin
Solved! Go to Solution.
Dear Nidhin,
According to ISO 129-1, the arc symbol is not on the value but on the side:
To add the arc symbol:
Click on "Properties"
Click on the arc dimension, then on "Fix Text"
Click on "Prefix"
Click on "Spec Chars"
Click on "ArcLength" then on "Apply"
Click on the green arrow
Done
Dear Nidhin,
According to ISO 129-1, the arc symbol is not on the value but on the side:
To add the arc symbol:
Click on "Properties"
Click on the arc dimension, then on "Fix Text"
Click on "Prefix"
Click on "Spec Chars"
Click on "ArcLength" then on "Apply"
Click on the green arrow
Done