Add additional fields for the tool type “Reaming”

[DT_14388472]

We would like to have three additional fields added in Creo NC for the tool type “Reaming”: “tip angle”, “tip offset”, and “tip diameter”.

"Picture 1 Reaming"

Our colleagues in programming would like to control the depth during programming—similar to “Drilling” and “Thread Cutting”—using these additional fields.

This would be a considerable relief during programming, as the chamfer/lead-in of the reamer would no longer need to be added to the depth manually.

Example for Drilling:

"Picture 2 Drilling"

Example for Thread Cutting:

"Picture 3 Thread cutting"

[Catalina]

Hi @DT_14388472 

Thank you for your question. 

Your post appears well documented but has not yet received any response. I am replying to raise awareness. Hopefully, another community member will be able to help.
 

Also, feel free to add any additional information you think might be relevant.

Thanks,