We have a requirement (based on geometry) to have several parts Injection Molded.
Small parts - Tight Tolerances - the usual problems.
We looked at ProtoMold - but they are not ITARS compliant.
Anyone have suggestions for a good house, willing to do short runs, and easy to work with - ITARS compliant.
Thanks in Advance.
Anthony R. Benitez
Senior Mechanical Designer
Drafting Supervisor
Applied Research Laboratories
The University of Texas at Austin
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
