cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

problem outputting circle statements with volume milling

Sean
1-Newbie

problem outputting circle statements with volume milling

Recently upgraded to WF-5 and have had problems with NC outputting thousands of points rather than a circle statement when cutting arcs. I have tried adjusting tolerances but it only changes the number of points. Anybody out there run into this or have a fix. Any help is appreciated. Thanks.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements