cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

trochoidal milling with 5-axis machining

NiWi95
2-Explorer
2-Explorer
‎Mar 06, 2020 07:26 AM
‎Mar 06, 2020 07:26 AM

trochoidal milling with 5-axis machining

I want to use trochoidal milling with 5 Axis machining. Is this function given in Creo 5.0? I added "trochoidal_milling" in the config.pro. After selecting the trajectory milling the two parameters "trochoid_width" and "trochoid_depth appear, where i can configure my milling path. When I switch to 5-axis machining the parameters disappear. Why is this happening? I am using Creo Parametric 5.0. Thank you in advance!
0 Kudos
Notify Moderator
1 REPLY 1
cfardmanesh
4-Participant
4-Participant
(To:NiWi95)
‎Apr 23, 2021 11:20 PM
‎Apr 23, 2021 11:20 PM

 Well there are bunch of things here. First some option will offer this param and is in your param option to look for and is toolpath type dependent. Basically, you pick the diameter you want near plunging tool options and you can't miss it. If it is not there mean that toolpath it doesn't offer.

0 Kudos
Notify Moderator
Announcements

Contact Community Management
Top Tags