Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Apparently I don't understand something about range variables.
I want L to range from 0.0001 to 0.001 and C to range from 1e-7 to 1e-6 using the following function.
f=1/(2*pi*L*C)
How do I set that up?
Mathcad has an extensive "Help" feature.
Please use it before wasting our time and good will.
Michael I am stunned that you would answer that way!
I have spent lots of time poring over the help and PTC's web site in order to figure this out.
Wow!
I agree. Nobody forces you to help, so if you feel the thread isn't worth your time, don't post.
Mike
A starting place:
I dont currently have Mathcad, but you could create a vector with your desired range or create a function which is dependant on the range variables.
