Annotation Unit change help needed

[GP_10708304]

I am using 20.6 Creo Elements direct,  When I am in annotation I can not change from INCH to metric as my default, I've tried changing the units, but they say they are already in MM, I also tried dimension properties but it will revert back to Inch after the selection. Any help would be greatly appreciated. 

[Kotom-Eng]

Please, give screenshots of how you change the units.

[GP_10708304]

My issue is I can't change to MM units and I need to. I did try system settings but it's already set in MM, the annotation stays in inch. I also tried dimension properties, but it will always revert back to INCH.

[ThomasKirkman · Accepted solution]

File-> settings -> Default Settings then go to dimensions text length unit style and change it. 

[GP_10708304]

Thanks for help, that was the issue!!!

[ThomasKirkman]

Glad to help

This change will be saved to c:\users\(username)\AppData\Roaming\PTC\Creo Elements Direct Modeling (Version number\Annotation.

in case you want to back it up.

Tom