sketch child of the frame
Jun 18, 2024
08:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jun 18, 2024
08:15 AM
sketch child of the frame
How can I load a sketch via command line that is placed as a child of the frame?
In my case I would like the "logo" sketch to be placed as a child of the "cart_A3" frame
the command line command to load the sketch is:
sd-am-load-sketch
I' have Creo Elements/Direct Modeling 20.5.1.0
2 REPLIES 2
Jun 18, 2024
04:38 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jun 18, 2024
04:38 PM
Andrea
This response is edited, as I found a much better way of doing it than my original response.
Since
is set as the
, you will not need to fill out the
. That is only used if you want the owner to be a specific view or specific sketch.
Adjustment
Regards
Tom
This response is edited, as I found a much better way of doing it than my original response.
Code:
(sd-am-load-sketch :file_name file_name :position position :owner_type :current-frame :owner owner <- you do not need this if you set the owner_type to :current-frame. :adjust adjustment)
Code:
:current-frame
Code:
:owner_type
Code:
:owner field
Adjustment
Code:
:upper_left :upper_middle :upper_right :middle_left :middle_middle :middle_right :lower_left :lower_middle :lower_right
Tom
Creo Element\Direct Modeling 20.6.0.0.0
Jun 26, 2024
09:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jun 26, 2024
09:31 AM
Hi @AR ,
I wanted to see if you got the help you needed. If so, please mark the reply as the Accepted Solution. It will help other members who may have the same question.
Of course, if you have more to share on your issue, please pursue the conversation.
Thanks,
Olivier
![](/skins/images/695EE5AD3E567050FEDD72575855ED93/ptc_skin/images/icon_anonymous_message.png)