Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X
My consulting firm needs to train a couple of SolidWorks users on Pro/E for a new project.
I went through the same process with Pro/E 2000i^2, and I found it frustrating. With so many similar concepts in the two programs, it’s too tedious to train users from the ground up about what a sketch and a protrusion are, etc. But the programs are still different enough that I know better than to just assume the SolidWorks folks will figure it out.
Any recommendations?
I've contacted our VAR (NxRev) to see what they offer and whether they can put together a custom course. I'm thinking a fast-paced 2-day course could work.
Also, I see that Roger Toogood is still cranking out training books. I ended up using some of his myself when I made the conversion. Not as efficient as having a SolidWorks-savvy trainer guide you through the differences, but at least you can go at your own pace.
Thanks,
Wallace
Summary:
Thanks for the replies. The options I found are
I've decided to give eLearning a try. We've got plenty of MEs here who are strong in both CAD packages, so we'll be able to point out the modules to focus on and guide them through. I also like that the users will be able to move more quickly than PTC's classroom pace if they're comfortable.
By the way, kudos to Impac Systems in TX. They got a good review and also responded directly to me with some input. (My company is in Seattle.)
Thanks again,
Wallace
In Reply to Wallace White:
My consulting firm needs to train a couple of SolidWorks users on Pro/E for a new project.
I went through the same process with Pro/E 2000i^2, and I found it frustrating. With so many similar concepts in the two programs, it’s too tedious to train users from the ground up about what a sketch and a protrusion are, etc. But the programs are still different enough that I know better than to just assume the SolidWorks folks will figure it out.
Any recommendations?
I've contacted our VAR (NxRev) to see what they offer and whether they can put together a custom course. I'm thinking a fast-paced 2-day course could work.
Also, I see that Roger Toogood is still cranking out training books. I ended up using some of his myself when I made the conversion. Not as efficient as having a SolidWorks-savvy trainer guide you through the differences, but at least you can go at your own pace.
Thanks,
Wallace