cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Assembling Config Option

SOLVED
Highlighted
Participant

Assembling Config Option

Can someone point me in the direction of the config option that controls when we "assemble" a component into the assembly if it is attached to the cursor or not.  We have 3 users, that the part is attached to the cursor and places where they click and we are troubleshooting an issue with this.

 

Thanks,

Erik

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Assembling Config Option

Look at the option: comp_assemble_start

Steve Williams
Pro/E Version 15/16 (Circa 1995/1996)

View solution in original post

3 REPLIES 3

Re: Assembling Config Option

Look at the option: comp_assemble_start

Steve Williams
Pro/E Version 15/16 (Circa 1995/1996)

View solution in original post

Re: Assembling Config Option

That was it! Now can you tell me why having this set to "move_then_place" will lock Creo 3.0 up for 5 minutes, but setting it to "default" works flawlessly? Haha. Just started happening in the last 2 weeks and we have done no updates to anything.

Re: Assembling Config Option

Unfortunately I don't know why it would add excessive time to assemble a component.

I do know that component interfaces that look for automatic placement add a lot of time to assembly.


Steve Williams
Pro/E Version 15/16 (Circa 1995/1996)