First of all I'm trying to create a pipeline between the green part on
the right, to the
CSYS on the blue part (see attached jpg).
I was able to create a route from the green part on the right; now I'm
trying to
extend a pipe-line from the blue part CSYS but do not have access to "X"
& "Y"
(see attached jpg).
NOTE: I do not want the line to be a straight pipe, point-to-point.
Sorry, it has been years since I used Pro/Piping.
Thank you.
-Art
If you are able to share a tutorial, that would be much appreciated.
WF 2.0
.
.
This message (including any attachments) contains
confidential and/or proprietary information intended
only for the addressee. Any unauthorized disclosure,
copying, distribution or reliance on the contents of this
information is strictly prohibited and may constitute a violation
of law. If you are not the intended recipient, please notify the
sender immediately by responding to this e-mail, and delete the
message from your system. If you have any questions about this
e-mail please notify the sender immediately.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
