cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Axis display for assembly

tushargadhave
10-Marble

Axis display for assembly

In assembllyl mode, if we select a part, its axis does not get highlighted in WF5.0 which used to happen in WF2.0.

This creates a lot of problem for complicated parts. It becomes difficult to indentify which axis belongs to which part.

Is there any way (may be some config option) so that axis of selected parts gets highlighted.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements
Attention: Creo 7.0 Customers
Please consider upgrading
End of Life announcement here.

NEW Creo+ Topics: PTC Control Center and Creo+ Portal