This isn't high on my priority list, but I'd like to know if it's possible to fix the as-stored configuration of a previous rev of a ProE drawing.
There is a drawing that is currently at the AD rev. One of the users noticed that the released AB rev doesn't reference the correct revisions of the models.
AB.0 = WIP Drawing As Stored config
|
+---> AA.X REL Models
AB.1 = REL Drawing As Stored config
|
+---> AC.X REL Models
As you can see the AB drawing doesn't reference the AB released models. There are AB released models.
Is there anyway after the fact to fix the as stored configuration so it points to the correct models?
Like I said, at this point it's water under the bridge, but I'd like know if it is possible to fix.
David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550
