cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X

Translate the entire conversation x

Auto-Associate location

Go to solution
BenLoosli
23-Emerald III
23-Emerald III
‎May 09, 2020 06:23 PM
‎May 09, 2020 06:23 PM

Auto-Associate location

When we check-in a new CAD file (part or assembly), we have auto-associate enabled. The user specifies the folder for the CAD file, but the WTpart file goes to a 'default' folder that is set in the OIR file. 

How do we get the WTpart file to go to the same folder  as the CAD part file automatically?

 

Creo 4m080

Windchill 11.0 m030

0 Kudos
Notify Moderator
ACCEPTED SOLUTION

Accepted Solutions
Serkan_ACAROGLU
11-Garnet
11-Garnet
(To:BenLoosli)
‎May 11, 2020 04:10 AM
‎May 11, 2020 04:10 AM

Below settings should help. There should not be any folder path in your wtpart oir file, leave it default.

 

Site Preferences > Store New Parts with CAD Documents = Yes

View solution in original post

Notify Moderator
1 REPLY 1
Serkan_ACAROGLU
11-Garnet
11-Garnet
(To:BenLoosli)
‎May 11, 2020 04:10 AM
‎May 11, 2020 04:10 AM

Below settings should help. There should not be any folder path in your wtpart oir file, leave it default.

 

Site Preferences > Store New Parts with CAD Documents = Yes

Notify Moderator
Announcements
Contact Community Management
Top Tags