cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Auto Create WTpart at same revsion as CAD parts

SOLVED
Highlighted
Sapphire II

Auto Create WTpart at same revsion as CAD parts

I have Windchill set to automatically create WTparts upon check-in of the CAD parts from a user workspace.  Our default version for new parts is A, but sometimes we want them in Windchill at 0. When that happens, we revise the part in the user workspace to version 0 and then do the check-in. However, the WTparts are being created at version A, not version 0 of the CAD parts. For version A parts this is fine. Is there a setting in Windchill that will create the WTparts at the same version as the CAD parts at initial check-in.

I suppose if we added the extra step of doing an Associate before the revise, then we could get everything to version 0 first, but that is an extra step, prone to error that I am trying to avoid.

 

Creo 4 m080

Windchill 11.0 m 030 CPS16

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Re: Auto Create WTpart at same revsion as CAD parts

There is a preference

 

-> Operation -> Auto Associate -> Set Revision For Part

 

Screenshot 2020-06-29 at 21.38.34.png

View solution in original post

1 REPLY 1
Highlighted

Re: Auto Create WTpart at same revsion as CAD parts

There is a preference

 

-> Operation -> Auto Associate -> Set Revision For Part

 

Screenshot 2020-06-29 at 21.38.34.png

View solution in original post

Announcements