cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Translate the entire conversation x

Moving assemblies from an eBOM to a mBOM without the child parts being included

LF_10749093
1-Visitor
1-Visitor
‎Nov 14, 2023 11:35 AM
‎Nov 14, 2023 11:35 AM

Moving assemblies from an eBOM to a mBOM without the child parts being included

I am using Windchill MPMLink Release 12.0

When I used BOM Transformer to move an assembly in the eBOM to the mBOM, it always moves all the child parts of the assembliy in the eBOM. For example, I may have a printed circuit board (100+components) in the eBOM. As the printed circuit board is made externally and delivered to the factory as a single part number (same revision as in the eBOM), I only want the printed circuit board to appear in the mBOM not the Printed circuit board and all of its child parts.

How can I move just the top level part number?
0 Kudos
Notify Moderator
1 REPLY 1
Fadel
22-Sapphire III
22-Sapphire III
(To:LF_10749093)
‎Nov 14, 2023 04:13 PM
‎Nov 14, 2023 04:13 PM

when you move (Drag and Drop) you are reusing the Design part in downstream so it will move the whole and this is expected.

To achieve your request , you have to copy from EBOM and paste under MBOM as new Branch with 'Do Not Duplicate' :

 

(view in My Videos)

 

Fede
Notify Moderator
Announcements

Contact Community Management
Top Tags