Some DRW's are not publishing

[Rahul_Rathore]

I published around 70 .drawings, Out of 70 drawings 61 are completed. But 9 drawings are getting fail with no error.

Even those drawings are not submitting to any cad worker to publish. 

I am attaching logs, Would be great if i can get the help.

Thank You..!!!

[BenLoosli]

What happens if you resubmit those jobs?

Is it the same jobs always failing or just random failures?

If the same file, then I would look to see what may be 'wrong' in the file. We had some fail due to Legacy Datums that had not been converted in Creo 7.

[Rahul_Rathore]

Hi BenLoosli

Thanks for your reply, I tried to resubmit the jobs. But jobs are getting fail without submitting to CAD worker.

It is the random failures, not always we are facing these kind of issue.

[avillanueva]

I found this online but you likely saw this:

https://www.ptc.com/en/support/article/CS39455

I doubt that you changed settings to not publish .drw files since you said it was random. I would look at your publishing rules since in the image it indicates you are using publishing rules. Perhaps there is a logic error that depending on state or some other attribute, you have not covered all cases.

[TomU]

The "No Processing Required" message is odd for a Creo drawing.  It's normally reserved for object types that Windchill can't publish.  It's probably worth opening a case with tech support to troubleshoot.

[jlecoz]

Looking your picture it seems you have a publishing rule enabled (listed in the Description field).

I would review the publishing rules criteria and investigate if this publishing rule is forbidding the drawing conversion.

Regards