WT Part attributes get into CAD Parameters

[Amirtharaj_K]

Hi Guys,

I want know can we get the WT Part attributes into CAD Parameters.

For example:

P1: I create a one attribute that name is "Type" with drop down list & added in WT Part.

P2: When i create a new WT part i set that "Type"

P3; Then i association with CAD i want to view that same attibutes name & value in CAD Parameter.

is it possible.

Regards,

Aj

[HelesicPetr]

Hi @Amirtharaj_K 

Yes if you propagate WTPart information to CAD Document

You just need to use Publish to CAD during check in operation

Also you can use a function from the Action menu on a WTPart detail page

PetrH

[Amirtharaj_K]

Thanks for the reply, Mr. Petr. I apologize for the delay in my response.

Once we publish into CAD, it will automatically go to CAD Parameters, right?

But i can't get this into CAD Parameter only i received 

i want when i create a WT part we filled few information right i want that attribute in CAD Parameters.

Aj

[avillanueva]

https://www.ptc.com/en/support/article/CS272669?source=search

This says that option is for publishing structure like with Top Down Design. I did not think it pushed attribute data too. Can you confirm that @HelesicPetr ?

[HelesicPetr]

Hi @avillanueva 

I can confirm that the value is pushed to the CAD Document from the WTPart after publishing to CAD

PetrH

[Amirtharaj_K]

Thanks for the replay Mr. Petr & Mr. Avil

Can you share that CAD data for this.

Regards,

Aj

[HelesicPetr]

Hi @Amirtharaj_K 

Sorry I can not share the CAD model. 

PetrH

[Amirtharaj_K]

alteast can you share that CAD data parameter tab.

AJ

[HelesicPetr · Accepted solution]

Hi @Amirtharaj_K 

Here is the creo parametric parameters table screen shot

there is an internal value from the enumerated value list. So the propagation works from WTPart. 

PetrH

[aacciano3]

@HelesicPetr 

Just curious,

This works only if the CAD Parameter "AV_CODE" was previously created in the CAD object, right?

Thanks

[HelesicPetr]

Hi @aacciano3 

No,

The previous iteration does not contain that parameter in the CAD Model.

The behavior could be affected by version of a creo  workgroup manager.

I tested windchill 12.0.2.7 and Creo 9.0.3.0

PetrH

[aacciano3]

@HelesicPetr ,

Thank you for the reply!

Good point, I will check in my current environment (Windchill 11.0-Creo 5.0.3), but good to know that it works on Windchill 12.0.2.7 and Creo 9.0.3.0!

Antonio