cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

released family table with missing components also released as indepentent parts. How do I take those released parts and make them part of the family table. (I can't figure out how to do it without a naming error.)

Newbie

released family table with missing components also released as indepentent parts. How do I take those released parts and make them part of the family table. (I can't figure out how to do it without a naming error.)

I am updating/revising an existing (already been released) family table. It has most of the dash numbers, but a few were created and released as stand alone parts. (Basically, -2, -3, -4, -8, -9, -10 are part of the family table and -5, -6, -7 are independent.) How can I merge these existing parts into the family table? Everything I've tried produces a naming error in the workspace.

1 REPLY 1
Highlighted

Re: released family table with missing components also released as indepentent parts. How do I take those released parts and make them part of the family table. (I can't figure out how to do it without a naming error.)

I have done this before.

Here is a community answer to the same question.

https://www.ptcusercommunity.com/thread/125110?&art_lang=en&posno=44&q=merge%20part%20into%20family%...

There is also a CS article on how to do this.

https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS4975&art_lang=en