(Creo Parametric 10.0 ) Before I do the analysis definition, I already add a servo motor. However, I can only use the motor when the type of the analysis is position. And the right three buttons can'...
Hello
I'm using the generative design application within creo 9 (9.0.3.0). When I've done my optimization and want to look at the stresses in the final design I can't see anything, It's on...
Hello PTC community, I am using Creo Simulate (version 7) to perform the following FEA study. I need to idealize four Guy wires within the genset exhaust and silencer assembly that will help stabi...
I am using Creo Simulate Release 4.0 and DatecodeM150 I have parts upon which we ran structural simulations in the past. I wish to now run a fresh simulation in assembly mode. When I have my assem...
Goodmorning to everyone,
I use Creo 8.0.9.0 and I'm wondering how to create an animation based on a MDO analisys that has the "real time duration".
If I set the time.duration of 10 seconds, I exp...
Is there a way in Creo Simulate to use a surface to create shell elements? This is not a midsurface shell compression. I created a simple "L" solid part with a surface extrusion. I ...
Hello community,
I need your support. Which solution is better?
How would you set the constraints and power? Is the solution approach using the creo assembly the right one?
Thank you f...
I'm attempting a study of a Macpherson strut and struggling to figure out how to input the damping characteristics. I have the Creo Mechanism dynamics option but as far as I can tell the dampin...
Are there any ideal parameter's that we need to pass from Creo Parametric to engineering notebook (Mathcad worksheet) and relatively the input parameter's from engineering book to Creo Parametric? I ...