Hello PTC community, I am using Creo Simulate (version 7) to perform the following FEA study. I need to idealize four Guy wires within the genset exhaust and silencer assembly that will help stabi...
Greetings! I would like to know if the self-weight of the simulated component needs to be inserted as a load or does it insert it automatically. For example, to calculate the displacement in a beam, ...
Hello All, We have a problem with the Ansys Simulation module in Creo 11.0.0.0. When we run the simulation with the default settings, it always shows the message: "Solve I Failed I 0% completed," ev...
I need the procedure to apply the moment load to this shaft. I cannot find anything on how to do this. I even tried two different AI website to try to find an answer. Neither site g...
Dear PTC Community, I am currently working on Creo Simulate to perform a FEA on a rain cowl assembly for different wind loadings and also to check if the current weight of this rain cowl assembly ca...
While using Creo 9 Mechanism Dynamics Option (MDO) for analyzing design system, user is getting the error "Mechanism Dynamics is required for this analysis type". After re-installation it worked. But...
... What might I (the instructor) try, to stop these crashes? Do we need to upgrade our computers? I suspect this is true. However, are there things we could change/try on t...
Hello, i've been trying to find big file of release notes not 2 page release notes about ptc creo simulate live 10.0. We are now on the edge of changing creo verions and i want to know if there are ...
Currently I have a contact model that consists of two separate bodies. One body is fully fixed and assigned a linear elastic material with steel properties. The second body rests on top of the first ...
Hi,
We need to find the stress when the part is twisted at an angle. It's shown in the capture-1 below that a motor powers the pocket at one end, while the other end has a stopper. lo...