cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Adding views in creo and floefd

SOLVED
ptc-4410620
Newbie

Adding views in creo and floefd

I started using creo and floefd on a different computer and I noticed that when I tried to change views there was no right side, front side, top, and bottom views. How do I add these views?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

Re: Adding views in creo and floefd

6 REPLIES 6

Re: Adding views in creo and floefd

Hi, to get this into the correct context ... can you please add which product you are refering to?

Creo Parametric, Creo Direct, Creo Elements/Direct Modeling Express 4.0 or the professional

version of Creo Elements/Direct Modeling?

A help here would be appreciated.

Re: Adding views in creo and floefd

Hi, I am using creo parametric. I think the part was modeled without using a template (which was modeled before I got it) and now I want to edit the part. There is only one view which is the front view.

Re: Adding views in creo and floefd

This session will be transfered to the Creo board to be routed correctly - this board here is about Creo Elements/Direct Modeling Express

Re: Adding views in creo and floefd

Where is the creo board located?

Re: Adding views in creo and floefd

Re: Adding views in creo and floefd

Thanks Kris

Announcements