Now that creo 1.0 has been released,
can someone confirm the following new features, ( I had that from people in PTC):
"In Creo 1, Mechanica is receiving a large number of functionality and usability enhancements. These include:
Generalization of Nonlinear analyses:
- LDA with Contact
- LDA with Plasticitiy
- LDA with axi-symmetry
- LDA enforced UCS displacements
- Nonlinear spring stiffness
- General methodology of ordering loads in Nonlinear analyses
- Temp dependent conductivity (nonlinear thermal)
- Temp dependent convection coefficients (nonlinear thermal)
- Gray body radiation conditions (nonlinear thermal)
More general Structural Temperature Load (non-uniform, different base temps, etc.)
Enhanced and generalized Base excitation capabilities for dynamic analyses (time, frequency, random)
vonMises stress calculations in dynamic random analysis
Animation of Dynamic Frequency results
Enhancement of the model and UI of Fasteners
Automatic definition of “bolt preload” for solids
Traveling heat loads
Mapped meshing capabilities (on quilts and solids)
Automatic techniques for meshing thin structures
Default results templates for Studies/analysis types
New ribbon UI consistent with all Creo apps"
is all that true?..where we can get more infomation.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
