Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
I'm just starting out using RSD 8.0 and Pro/E 4.0 Cabling.
What's best practices to setup the cabling assemblies structure?
Here is my currentassy model tree setup:
- AircraftInstallation CableAssy
- Skeleton Model .prt
- Shrinkwrap (Aircraft Top Level Assy)
- Cable Assy 1
-Copy Geometry (p-clamp location)
- Cable Assy 2
Copy Geometry (p-clamp location)
Is this correct? Or is there a better way?
Thanks,
Sun