Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
Good morning,
In my drawing, for a created dimension, I cannot change the tolerance, mode to enter a ± tolerance. I have looked through past threads add tried several things others have posted on this topic. In my config file, I have set
1. tol_display = yes
2. tol_mode= limits
3. tbl_driven_tol_val_edit = yes.
I am using WF4, M220 if thay matters.
Thanks, Bert
That was it. Thanks.