Can't change tolerance mode

[davehaigh]

I just noticed this morning that the tolerance mode is grayed out on my model dimensions.

I created a new part starting with "Empty". No template part. Same behavior. This is new to me.

Any ideas what's up?
Config option?

WF4 - m170

David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[ptc-2607046]

Sounds like you are setup to use tolerance tables, and the config option “tbl_driven_tol_val_edit” is set to “no”.

[BenLoosli]

Look at your setting for tol_display in config.pro. If set to YES, then I can change the dimension property tolerance mode.

Thank you,

Ben H. Loosli
USEC, INC.