Can't change tolerance mode

[ptc-2803703]

Good morning,

In my drawing, for a created dimension, I cannot change the tolerance, mode to enter a ± tolerance. I have looked through past threads add tried several things others have posted on this topic. In my config file, I have set

1. tol_display = yes

2. tol_mode= limits

3. tbl_driven_tol_val_edit = yes.

I am using WF4, M220 if thay matters.

Thanks, Bert

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[mdebower]

Bert,

There are also options in the Drawing Options file that need to be set in addition to the configuration file options. Not sure you set them in both or not...

-marc

[mpeterson]

Bret,

Yes there is a setting in the Drawing Options to show tolerances. - tol_display - yes

Mark Peterson
Design Engineer
Varel International
-

[ptc-2803703]

That was it. Thanks.